Reading garbage from serial port, reborn
I just got the pitinfo v1.2 throwing garbage at me.
I have tried different settings for serial port ( baud, parity, flow control), using picocom and https://hallard.me/enable-serial-port-on-raspberry-pi/
I have check cabling by connecting module directly to EDF appliance
Any idea (Ie proper serial port settings)
Thanks in advance
What version of PI and EdF counter do you have RPI 3, Linky, ... ?
@Charles It's a RPI 3 and a linky.
Thomas, there is a problem detected by Linky users, to be able to works a resistor need to be changed.
- R3 (4.7K) need to be changed by 1K, 1.2K or 1.5K (and may be 2.2K) whatever you have in hand.
- or put another resistor from 800 Ohm to 1.8K in // of R3 leaving R3 in place.
If you can't do it, you can send me back the board and I'll do it for you.
@Charles Thanks for the feedback. I am out of office ATM. I'll see what i can do at end of week. But my soldering skills are poor.
you can send me back the board and I'll do it for you.
what is the address i should send back the borard ?
Je viens d'envoyer un PM sur le Chat avec l'adresse